Snom: M300 Manual Configuration
Written by Marissa Orsini
Updated at April 25th, 2023
Table of Contents
Scope:
The following document will show you how to manually provision Snom M300 Phone
Requirements:
- Access to Snom web GUI
- Access to Manager Portal
- Phone's MAC address must already have been added to a user in the Manager Portal
Configure Snom Base Phone
- Using any web browser navigate to the IP address of the phone.
- Click on the Servers tab, click Add Server and populate the following fields, click Save
- Register : <domain>
- Outbound Proxy: <sbc>:5060 ( Refer to SBC Url here )
- Click on the Extensions tab, click Add Extension, and populate the following fields, Click Save
- Extension: <user extension>
- Authentication User Name: <Username>
- Authentication Password: <Password>
-
Display Name: <User Extension>
Note: These are the SIP Info you need for the extension
- Click on the Extensions tab, Click Handset -> Click Add handset
- Enter the IPEI of the handset, click Save
To get the IPEI, on the handset, go to settings -> status -> scroll down and look for the IPEI - Click on the Extensions tab, Click the Handset tab, and check the checkbox next to the extension you added. Click on Start SIP Registration.
- Now check the State of the extension, it should show SIP Registered.
- If it shows SIP Error, make sure you entered the correct SIP Credentials and check the SIP Log to make sure that it's sending the registration. The SIP Log will give you some details on the SIP Messages error.