cnPilot R200/R201: Manual Configuration
Written by Marissa Orsini
Updated at April 25th, 2023
Table of Contents
Scope:
The following steps will allow you to configure a cnPilot R201 manually for use with your Hosted PBX service. Tested with Firmware S4.4.2-R2
Requirements:
- Access to cnPilot web GUI
- Access to Manager Portal
Obtain SIP Credentials
- Log into Manager Portal
- Navigate to Phones
NOTE: Office Managers can navigate to Users > select the user > Phones
- Select Phone Info for the phone you wish to register.
NOTE: You will only see the information if the phone model is set to Manual or Softphone
- Take note of the listed information.
- Click Cancel when you are finished
Configure cnPilot R201
- Using any web browser navigate to the IP address of the router
- Select FXS1/FXS2 > SIP Account
- Configure the following fields, leaving all others default
- Line Enable: Enable
- Outgoing call without Registration: Disable
- Proxy Server: Enter the Domain / Proxy
- All ports should be 5060
- Outbound Server: Enter the Outbound Proxy
- Display Name: User's Name
- Account: Enter the Username
- Phone Number: Enter the Username
- Password: Enter the Password
- Click Save
- Reboot Device