Cisco: Manual Configuration
Written by Marissa Orsini
Updated at April 25th, 2023
Table of Contents
Scope:
The following steps will allow you to configure a Cisco desk phone manually for use with your Hosted PBX service.
Requirements:
- Access to Cisco web GUI
- Access to Manager Portal
Obtain SIP Credentials
- Log into Manager Portal
- Navigate to Phones
NOTE: Office Managers can navigate to Users > select the user > Phones
- Select Phone Info for the phone you wish to register.
NOTE: You will only see the information if the phone model is set to Manual or Softphone
- Take note of the listed information.
- Click Cancel when you are finished
Find IP Address
- From the Cisco phone select Setup
- Select Network > IPv4 Status
- Note the IP Address
Configure Phone
- Using any web browser navigate to the IP address from the above step
- Click on Admin Login > Advanced
- Click on Voice > Ext 1 at the top
- Complete the following, leaving all other fields as default
- Mailbox ID: 9901
- Mail Server: Enter the Outbound
- Proxy: Enter the Domain / Proxy
- Outbound Proxy: Enter the Outbound Proxy
- Use Outbound Proxy: yes
- Register: yes
- Display Name: User's Name
- User ID: Username
- Use Auth ID: yes
- Auth ID: Username
- Password: Password
- Click Submit All Changes
