Configure Paging Sender

Via Override

1. Log in to the Manager Portal
2. Go to Inventory > Phone Hardware
3.  Click Edit for the device you would like to set up
4. Go to Advanced > Overrides and enter the following:

NOTE: Replace "X" with whichever line key number you would like to set up Paging on

#Multicast Paging
linekey.X.type="24"
linekey.X.value="224.0.1.116:5001"
linekey.X.line="0"
linekey.X.label="Paging"
linekey.X.extension="0"
linekey.X.xml_phonebook="0"

  5. Click Save and Resync

Via Web GUI

1. Obtain the IP address of the phone and log onto the web GUI.
2. Select DSS Key.
3. In the desired Line Key, select "Paging" from the Type dropdown menu.
4. Enter 224.0.1.116:5001 on "Value" field.
5. Enter the name under the "Label" field. This will be the name shown on the phone screen.
6. Enter 0 under the Extension field. This is for the channel you will be used for paging. 
7. Click Confirm to accept the changes.
8.  A-Line key will appear on your phone screen. This is where you will be able to press on a key and talk to listeners.

Configure Paging Receiver

Via Override

1. Log in to the Manager Portal
2. Go to Inventory > Phone Hardware
3. Click Edit for the device you would like to set up
4. Go to Advanced > Overrides and enter the following:

#Paging Receiver Setup
multicast.listen_address.1.label="<Client Name>"
multicast.listen_address.1.ip_address="224.0.1.116:5001"

   5. Click Save and Resync

Via Web GUI

1. Go to Directory > Multicast IP
2. Enter 224.0.1.116:5001 under "Listening Address" 
3. Enter any name under the "Label" field. This will show as a caller ID when sender multicast to all listeners.
4. The same channel you set up for the Sender. This will allow the Listening phone to receive the Sender's Page. In this case, set it to 0. 
5. Click Confirm.

Barge Priority

• By default, incoming pages will cause active calls to be placed on hold. If you want phones to ignore multicast pages, you need to disable the paging priority setting for the receiving phones.  You can do this with the override below. In the example, replace x with the desired priority. If configured as 0, this setting will be disabled and all active calls will be configured as the highest priority

multicast.receive_priority.priority="x"

• Otherwise, you can set the priority of each phone, and phones will answer the incoming multicast paging calls with a higher priority and ignore those with a lower priority.  In the example, replace x with the desired priority. 

multicast.receive_priority.enable="x"

• This override will not allow the current caller to be interrupted while on the phone by an incoming page at all.

multicast.receive_priority.enable="0"
multicast.receive_priority.priority="0"