Algo: Manual Configuration
Written by Marissa Orsini
Updated at August 23rd, 2024
Table of Contents
Scope:
The following document will show you how to manually configure an Algo device.
Requirements:
- Access to the web gui for the device
- Access to Manager Portal
Obtain Your Softphone Information
- Log into Manager Portal.
- Navigate to Phones
NOTE: Office Managers can navigate to Users > select the user > Phones
- Select Add Phone and select any phone from the list to create a dummy phone, set Line Number to 1, and click add without entering any mac address.
- Select Phone Info for the phone you have just added.
NOTE: You will only see the information if the phone model is set to Manual or Softphone
5. Take note of the listed information.
- Click Cancel when you are finished.
Configure Algo Device
- Log in to the web GUI of the device. (Default password: algo)
- Click on Basic Settings and then SIP.
-
Enter the information below and then click Save:
- SIP Domain (Proxy Server): Domain/Proxy from phone settings.
- Page Extension: Username from the phone settings.
- Authentication ID: Username from the phone settings.
- Authentication Password: Password from the phone settings.
-
Display Name: Extension name.
- Click on Advanced Settings and Advanced SIP.
- Click on Enabled for SIP Outbound Support.
- Add the Outbound Proxy from the phone settings.
NOTE: The Outbound Proxy should be entered with a :0 at the end (sbc.ucaasnetwork.com:0) - Click on Save.