Grandstream DP752: Manual Configuration
Written by Marissa Orsini
Updated at April 25th, 2023
Scope:
The following steps will allow you to manually configure a Grandstream wireless base.
Requirements:
- Grandstream Wireless Base (DP752, DP750, etc.)
- Access to Manager Portal
- Access to Grandstream Device Web GUI
Obtaining SIP Credentials
- Log into the Manager Portal.
- Click on Users at the top.
- Find your extension number.
- At the far right, click on the pencil and then Phones.
- SIP credentials will only be available for Manual or Softphones. Click on the phone you would like the credentials for.
- Note the details on the popup.
Configuring the Base
- Using any web browser navigate to the IP address of the base.
- Navigating to Status > Base Status
- Log in. The default username is admin, the password will be located on the tag at the back of the base.
- Click on Profiles > Profile 1 > General Settings
- Fill out the following:
- SIP Server: Domain/Proxy from the step above
- Outbound Proxy: Outbound Proxy from the step above
- Voice Mail Access Number: 9901
- Now go to Dect > SIP Account Settings
- Here is where you will configure the SIP Credentials.
- Under the account you would like to configure, fill out the following:
- SIP User ID: Username from the step above
- Authenticate ID: Username from the step above
- Password: Password from the step above
- Make sure that the Profile is set to the profile we configured in the step above ex. Profile 1 and that that HS Mode is set to the handset you are setting up.